Search found 5 matches
- Fri Apr 29, 2011 10:05 pm
- Forum: Support
- Topic: NUCORE Installed, Couple Issues
- Replies: 28
- Views: 62360
Re: NUCORE Installed, Couple Issues
The lights are tested by pulsing a capacitor, waiting a fixed delay and reading back the voltage. If your processor is running to slow, that would cause random bulbs to look bad. I suspect that is why Chuck asked about your processor. Also you need to disable cool and quiet in the bios and any other...
- Fri Apr 02, 2010 9:10 pm
- Forum: General
- Topic: My Nucore Installation - Ground Loop Noise Solution
- Replies: 6
- Views: 18923
Re: My Nucore Installation - Ground Loop Noise Solution
When I designed our audio amp, I struggled with noise. The original amp used a digital signal and the amplifier was muted during silence. There was virtually no noise. The problem with using the P.C. power supply is that it brings the noise right into your circuit. There are differences in the groun...
- Mon Dec 07, 2009 8:08 pm
- Forum: Support
- Topic: ethernet driver for GIGABYTE GA-G31M-ES2L Intel MB
- Replies: 0
- Views: 7978
ethernet driver for GIGABYTE GA-G31M-ES2L Intel MB
This motherboard does not come with Linux drivers so you have to supply your own. 1) Download the file below and burn it to a CD for safe keeping and later use. 2) log in as root 3) use the file viewer to extract the driver to /root or type tar -xjvf atl1e.tar.bz2 4) cd atl1e/src 5) make install 6) ...
- Mon Dec 07, 2009 7:06 pm
- Forum: Support
- Topic: Ethernet fix for FoxConn M.B. A6VMX2
- Replies: 2
- Views: 15122
Ethernet fix for FoxConn M.B. A6VMX2
Instructions for FoxConn Motherboard A6VMX2-K ethernet fix The problem is that the Realtek ethernet chip is not properly initialized. The driver r8169 is selected automatically by Linux and doesn't work. The current solution is to downgrade the driver to r8168. Follow the steps below, the `uname -r`...
- Wed Feb 13, 2008 11:26 pm
- Forum: General
- Topic: Lets go around the room
- Replies: 12
- Views: 18266
I've been programming video games with Chuck for 25 years. I design circuit boards and do embedded programming for a living. I always loved pinball but the places around here sell beat up games for way too much. It wasn't until 3 years ago that I found out about RGP and buying games from collectors....