Search found 13 matches

by TheBaronVonBell
Tue Feb 22, 2011 10:11 pm
Forum: Support
Topic: swep1 sound problem again.
Replies: 11
Views: 19307

Re: swep1 sound problem again.

Found! Pinched wire in a hard to see place. Thanks to Eric for the tip on where to look!
Tim
by TheBaronVonBell
Tue Feb 22, 2011 2:06 pm
Forum: Support
Topic: swep1 sound problem again.
Replies: 11
Views: 19307

Re: swep1 sound problem again.

Eric, The amp does have power. (led is on) As for the wiring I will check again when I get off work at 5. Okay if I call you after 5pm central?
Tim
by TheBaronVonBell
Mon Feb 21, 2011 11:35 am
Forum: Support
Topic: swep1 sound problem again.
Replies: 11
Views: 19307

Re: swep1 sound problem again.

Update: Ran alsamixer again and the headphone output is at zero, but not muted. I can select it but cannot increase the volume.
by TheBaronVonBell
Thu Feb 17, 2011 9:38 pm
Forum: Support
Topic: swep1 sound problem again.
Replies: 11
Views: 19307

Re: swep1 sound problem again.

Yes, 8.04 LTS rev 2. Motherboard is a asus m2n68-am plus.
by TheBaronVonBell
Thu Feb 17, 2011 11:08 am
Forum: Support
Topic: swep1 sound problem again.
Replies: 11
Views: 19307

Re: swep1 sound problem again.

Assuming that the original amp was not the problem, and that I got a new cable with my nucore amp, that would mean both cables were bad. I think this is unlikely. Also when I unplug the cable from the computer sound jack you immediately hear the pop from the speakers. So, I think the amp and speaker...
by TheBaronVonBell
Wed Feb 16, 2011 11:47 pm
Forum: Support
Topic: swep1 sound problem again.
Replies: 11
Views: 19307

swep1 sound problem again.

Ok, this one is really confusing. I unplugged my machine and moved it. When I plugged it back in everything booted ok, Game plays but no sound. Went into the system bios and checked to make sure audio was enabled, then checked alsamixer to make sure levels were turned up. Everything checked out ok b...
by TheBaronVonBell
Tue Aug 10, 2010 11:48 am
Forum: Support
Topic: SWEP1 won't start
Replies: 5
Views: 7949

Re: SWEP1 won't start

I was still having trouble with occasional "no boot" on the game so, I decided to replace the USB cable thinking it might be defective. When I unplugged it, the usb connector on the Nucore board fell off. (Probably what was causing the intermittent boot problem) How can I get the Nucore bo...
by TheBaronVonBell
Wed Jul 14, 2010 11:08 pm
Forum: Support
Topic: NEED HELP UPDATING AUDIO DRIVERS FOR NEW MOTHERBOARD
Replies: 6
Views: 8869

Re: NEED HELP UPDATING AUDIO DRIVERS FOR NEW MOTHERBOARD

USB board was connected ok, I rebooted and went into the system bios and changed the audio front panel settings to AC97 from HD and it worked. I'll wait and see if the problem comes back.
Tim
by TheBaronVonBell
Wed Jul 14, 2010 10:31 pm
Forum: Support
Topic: NEED HELP UPDATING AUDIO DRIVERS FOR NEW MOTHERBOARD
Replies: 6
Views: 8869

Re: NEED HELP UPDATING AUDIO DRIVERS FOR NEW MOTHERBOARD

Ok, I did the total wipe and reinstall. Now the game won't boot at all. Once it gets past the Nucore 1.0 splash screen it says: Starting emulation ****reset***** Nucore Shutdown Watchdog sleeping during shutdown audio shutdown launcher(6) hardware error running local boot scripts (etc/rc.local) Then...
by TheBaronVonBell
Wed Jul 14, 2010 3:55 pm
Forum: Support
Topic: NEED HELP UPDATING AUDIO DRIVERS FOR NEW MOTHERBOARD
Replies: 6
Views: 8869

Re: NEED HELP UPDATING AUDIO DRIVERS FOR NEW MOTHERBOARD

Yes I did. Do I need to do a total wipe on the Hard drive and start over?
Tim
by TheBaronVonBell
Tue Jul 13, 2010 10:15 pm
Forum: Support
Topic: NEED HELP UPDATING AUDIO DRIVERS FOR NEW MOTHERBOARD
Replies: 6
Views: 8869

NEED HELP UPDATING AUDIO DRIVERS FOR NEW MOTHERBOARD

My original foxconn mb died after only 3 months so I replaced it with an asus m2n68-am plus. everything works ok except the game sound (very soft) I tried maxing out the settings in alsamixer with no effect. I went to the realtek site and downloaded the latest driver set for linux but I need some he...
by TheBaronVonBell
Thu Jun 17, 2010 6:40 pm
Forum: Support
Topic: SWEP1 won't start
Replies: 5
Views: 7949

Re: SWEP1 won't start

I checked both usb plugs and they were both seated well, I unplugged and replugged them anyway and now it boots. Go figure. I was thinking back to when it wouldn't boot and I seem to remember some message flying by about some check or other not having been performed in x times and it said "chec...
by TheBaronVonBell
Wed Jun 16, 2010 10:24 pm
Forum: Support
Topic: SWEP1 won't start
Replies: 5
Views: 7949

SWEP1 won't start

After the nucore splash screen the monitor displays "nucore desktop login" game was working fine until I left it unplugged for a couple of days. How do I get it to run the game software again?

Tim