Search found 8 matches

by Todd
Wed Nov 02, 2011 7:01 pm
Forum: Support
Topic: Game will not start (PLAY) SWE1
Replies: 0
Views: 25169

Game will not start (PLAY) SWE1

I have gotten to final step with the Nucore system. Every thing is up and running. I am now in attract mode and have made all the adjustments, tested all switches and coils. I close the coin door, the game reads "Free Play" .... Ready! I push the START Button.... Nothing. When I go back to...
by Todd
Tue Nov 01, 2011 9:39 pm
Forum: Support
Topic: USB to board connection
Replies: 10
Views: 24981

Re: USB to board connection

My own knowledge of board repair is limited. I don't think I am up to tackling this. The person who does my tough board work does not work on these boards either. Who do you recommend? Everything is connected properly (Checked, double checked, triple checked, quadruple checked). One more step and I ...
by Todd
Tue Nov 01, 2011 6:56 pm
Forum: Support
Topic: USB to board connection
Replies: 10
Views: 24981

Re: USB to board connection

The game had a bad cpu board. It had been scratched by something like a screwdriver. I purchased the game for one thousand dollars from a vendor that did not want to deal with the problem. I decided to sell the Prism cards to help pay for your Nucore system. After a couple of years of assembly, I am...
by Todd
Mon Oct 31, 2011 8:20 pm
Forum: Support
Topic: USB to board connection
Replies: 10
Views: 24981

Re: USB to board connection

I am running the software through an Asus PSG45T-M Mother Board running a 3G Intel dual core fed from a Western Dig 500G 7500 rpm hard drive. No luck on the game start. It looks beautiful in attract mode but I would really like to play a game.
by Todd
Mon Oct 31, 2011 4:52 pm
Forum: Support
Topic: USB to board connection
Replies: 10
Views: 24981

Re: USB to board connection

parallel port was backwards on the motherboard. I will try and reset the dongle. Still at it and checking back to see your response.

Take care,
by Todd
Sun Oct 30, 2011 11:43 pm
Forum: Support
Topic: USB to board connection
Replies: 10
Views: 24981

Re: USB to board connection

Strange,

on the third reboot I had limited success. All came to life and a game credit was entered and.... nothing.
Dang! What now. I cannot get the game to start. All switches and solenoids are good. Sooo close.
by Todd
Sun Oct 30, 2011 8:44 pm
Forum: Support
Topic: USB to board connection
Replies: 10
Views: 24981

Re: USB to board connection

Okay, I have connected to the parallel port (Oh, it's a dongle not an adapter). Still no power up to the playfield and no interface. The light saber flashes on briefly when I reset. Was the driver board damaged during all of my screwing around? If the cable is good, I will try to swap boards with so...
by Todd
Sun Oct 23, 2011 9:31 pm
Forum: Support
Topic: USB to board connection
Replies: 10
Views: 24981

USB to board connection

I have been putting off asking this. I have set up an external unit and successfully gotten to the final step. I am asked to select my game and I have no response when using the select buttons. Have I connected to the driver board wrong? I see the 5v light on the driver board when the game is not po...