Nucore Boot-up

Talk about anything PB2K related.
Post Reply
PATRICK
member
Posts: 3
Joined: Fri Apr 27, 2012 12:54 pm

Nucore Boot-up

Post by PATRICK »

Hello, my name is Patrick.
I have a probleme in the demarrage of my pinball machine, my screen is freeze "fig 38 on manual".
My installation is good, no error,roms is up todate etc...

Please help me.

I want to play with my RFM. :oops:

PS: My RFM is full opérationnel with old pc and prism card

psps: sorry for my english, i'm french :mrgreen:
User avatar
Chuck
Site Admin
Posts: 1546
Joined: Wed Mar 28, 2007 3:34 pm
Location: Michigan
Contact:

Re: Nucore Boot-up

Post by Chuck »

The system isn't able to communicate with the driver board if you are frozen here. Have you tried hitting the flipper button to see if the game changes? If nothing changes make sure the parallel port is properly connected and that the parallel port is set to port 378 in bios.
PATRICK
member
Posts: 3
Joined: Fri Apr 27, 2012 12:54 pm

Re: Nucore Boot-up

Post by PATRICK »

Thank you for your fast reponce.

No effect with buttons, i don't remember if the address is 378h.
I check tomorrow.


Thank you again :P
Last edited by PATRICK on Wed May 02, 2012 4:48 am, edited 1 time in total.
PATRICK
member
Posts: 3
Joined: Fri Apr 27, 2012 12:54 pm

Re: Nucore Boot-up

Post by PATRICK »

Hello,
my // port is in 378h irq 5.
i tried with ecp mode, epp mode and both nothing change.

Only one information for you, i dont find the driver for my integred sound card alc887.
My configuration is without sound.
My computeur machine is asus f1a 55-m lx with 4 Go ram and athlon processor.

Thanks for your help.
:roll:
Post Reply