SWEP1 won't start

Support questions and answer and latest software.
Post Reply
TheBaronVonBell
member
Posts: 13
Joined: Thu Nov 12, 2009 2:24 pm
Location: Fort Smith, AR

SWEP1 won't start

Post by TheBaronVonBell » Wed Jun 16, 2010 10:24 pm

After the nucore splash screen the monitor displays "nucore desktop login" game was working fine until I left it unplugged for a couple of days. How do I get it to run the game software again?

Tim

User avatar
Chuck
Site Admin
Posts: 1546
Joined: Wed Mar 28, 2007 3:34 pm
Location: Michigan
Contact:

Re: SWEP1 won't start

Post by Chuck » Thu Jun 17, 2010 12:28 am

Check and make sure your USB board is plugged in properly.

TheBaronVonBell
member
Posts: 13
Joined: Thu Nov 12, 2009 2:24 pm
Location: Fort Smith, AR

Re: SWEP1 won't start

Post by TheBaronVonBell » Thu Jun 17, 2010 6:40 pm

I checked both usb plugs and they were both seated well, I unplugged and replugged them anyway and now it boots. Go figure. I was thinking back to when it wouldn't boot and I seem to remember some message flying by about some check or other not having been performed in x times and it said "check forced" Is that something Linux does?

Tim

User avatar
Chuck
Site Admin
Posts: 1546
Joined: Wed Mar 28, 2007 3:34 pm
Location: Michigan
Contact:

Re: SWEP1 won't start

Post by Chuck » Thu Jun 17, 2010 7:04 pm

TheBaronVonBell wrote:I checked both usb plugs and they were both seated well, I unplugged and replugged them anyway and now it boots. Go figure. I was thinking back to when it wouldn't boot and I seem to remember some message flying by about some check or other not having been performed in x times and it said "check forced" Is that something Linux does?

Tim
Yeah, linux forces a hard drive check after every 20 boots (right around that many anyway.) Good to let it run.

TheBaronVonBell
member
Posts: 13
Joined: Thu Nov 12, 2009 2:24 pm
Location: Fort Smith, AR

Re: SWEP1 won't start

Post by TheBaronVonBell » Tue Aug 10, 2010 11:48 am

I was still having trouble with occasional "no boot" on the game so, I decided to replace the USB cable thinking it might be defective. When I unplugged it, the usb connector on the Nucore board fell off. (Probably what was causing the intermittent boot problem) How can I get the Nucore board repaired?

Tim

User avatar
Chuck
Site Admin
Posts: 1546
Joined: Wed Mar 28, 2007 3:34 pm
Location: Michigan
Contact:

Re: SWEP1 won't start

Post by Chuck » Tue Aug 10, 2010 11:57 am

I sent instructions via your email.

Post Reply