After the nucore splash screen the monitor displays "nucore desktop login" game was working fine until I left it unplugged for a couple of days. How do I get it to run the game software again?

Tim

Check and make sure your USB board is plugged in properly.

I checked both usb plugs and they were both seated well, I unplugged and replugged them anyway and now it boots. Go figure. I was thinking back to when it wouldn't boot and I seem to remember some message flying by about some check or other not having been performed in x times and it said "check forced" Is that something Linux does?

Tim

TheBaronVonBell wrote:I checked both usb plugs and they were both seated well, I unplugged and replugged them anyway and now it boots. Go figure. I was thinking back to when it wouldn't boot and I seem to remember some message flying by about some check or other not having been performed in x times and it said "check forced" Is that something Linux does?

Tim

Yeah, linux forces a hard drive check after every 20 boots (right around that many anyway.) Good to let it run.

I was still having trouble with occasional "no boot" on the game so, I decided to replace the USB cable thinking it might be defective. When I unplugged it, the usb connector on the Nucore board fell off. (Probably what was causing the intermittent boot problem) How can I get the Nucore board repaired?

Tim

I sent instructions via your email.