Page 1 of 1

Nucore Jumper J3

Posted: Fri Apr 20, 2012 4:38 pm
by Doug Piranha
There was no jumper or I lost it, any electrical bridge for J3 will work...right?

and J3 has to be bridged to get it to work?

Re: Nucore Jumper J3

Posted: Fri Apr 20, 2012 4:59 pm
by Chuck
That enables the battery. So yes, it should be jumped.

Re: Nucore Jumper J3

Posted: Fri Apr 20, 2012 6:15 pm
by Doug Piranha
Ty.

The instructions indicate to download the Nucore Rom package from www.pinball.com. Thats now planetary pinball...right?

I can't find the nucore.tar.tar file on their site. Help is appreciated.

Without completing the download and copy of files to my Nucore directory the Nucore program does load but I assume since the instructions say to get the roms I am still incomplete.

as a note, I am building a SWE1 from a NOS playfield and old cabinet that the playfield and pc was removed from. When I turn on the power to the pc, if the power driver board is "hot", I am only getting a few of the LED's on the board and the Nucore software won't load. It gives and error message and kicks to the dos prompt. If I turn off the power driver board Nucore boots up just fine and goes to the press buttons to load SWE1.

Help is appreciated I am not always the brightest star in the sky :-)

Re: Nucore Jumper J3

Posted: Fri Apr 20, 2012 7:19 pm
by Chuck

Re: Nucore Jumper J3

Posted: Sat Apr 21, 2012 12:27 pm
by Doug Piranha
woot its all working except have to work on soundcard.

Thanks