Support questions and answer and latest software.
3 posts • Page 1 of 1
I just finished shopping out my RFM, which also involved installing Bill Ung's UFO light kit. There is a problem, but I don't know if it lies with the kit or with Nucore so I'm posting here and emailing Bill for advise. Does anyone else have the kit installed in their Nucore system? The issue mine has is that Bill's board never completes the boot sequence. According to his instructions, LED #3 on his board should be lit until the RFM boot sequence is complete, at which point the LED will go out. My LED #3 is always on. The UFO lights do light up, but the various sequences never start.