Is there a video around anywhere that shows off the anti-aliasing and smoother framerate of NuCore very well? An a/b comparison would be really great. So far, I haven't found anything scrounging around on youtube.
Thanks,
E
Looking for a good demo video of NuCore
Re: Looking for a good demo video of NuCore
The anti-aliasing was pulled for the time being. The smoother frame rate can be seen in some of the video we have on the site. The problem is that I don't have a very good video camera :p One of these days I plan to buy an HD camera and that would hoepfully do a little justice. Where are you located?epthegeek wrote:Is there a video around anywhere that shows off the anti-aliasing and smoother framerate of NuCore very well? An a/b comparison would be really great. So far, I haven't found anything scrounging around on youtube.
Thanks,
E
Re: Looking for a good demo video of NuCore
I'm in SE Wisconsin, so I can't just drop by and check it out if that was where you were going.
Trying to decide if replacing a functional p2k computer is justifiable, or crazy.
Trying to decide if replacing a functional p2k computer is justifiable, or crazy.
Re: Looking for a good demo video of NuCore
I'm speaking at MGC later this month. I'm going to bring one of our complete units and I'll try to see if someone is bringing a pin2k machine that I could install it in.epthegeek wrote:I'm in SE Wisconsin, so I can't just drop by and check it out if that was where you were going.
Trying to decide if replacing a functional p2k computer is justifiable, or crazy.
Re: Looking for a good demo video of NuCore
I finally found the official videos on the site - the 'media' section isn't linked from the main page, but it is on the 'nucore' section (in the navigation at the top). I was just not finding any video previously.
The frame rate in the RFM demo video really does look impressive.
You mentioned the AA was pulled; is that still a possibility? Too taxing on the system? Not enough people buy higher end monitors to be worth the time at this point?
The frame rate in the RFM demo video really does look impressive.
You mentioned the AA was pulled; is that still a possibility? Too taxing on the system? Not enough people buy higher end monitors to be worth the time at this point?
Re: Looking for a good demo video of NuCore
I pulled the anti-aliasing because we could only do it on the vertical scanlines and not the horizontal. It made it look slightly better but the frame rate did take a hit on the slowest suggested processors amd x2 4400. I will probably take a look at it in the future. Right now we're busy adding new features that are more compelling.epthegeek wrote:I finally found the official videos on the site - the 'media' section isn't linked from the main page, but it is on the 'nucore' section (in the navigation at the top). I was just not finding any video previously.
The frame rate in the RFM demo video really does look impressive.
You mentioned the AA was pulled; is that still a possibility? Too taxing on the system? Not enough people buy higher end monitors to be worth the time at this point?
Re: Looking for a good demo video of NuCore
Can you tell us something of the new features coming up, or are they top-secret?Right now we're busy adding new features that are more compelling.
Re: Looking for a good demo video of NuCore
I always tell you all I can tell youknapejor wrote:Can you tell us something of the new features coming up, or are they top-secret?Right now we're busy adding new features that are more compelling.
Some things are "secret" and others I hate to announce until they are pretty far along. I don't like announcing anything unless I'm sure we can follow through with it.
Re: Looking for a good demo video of NuCore
I understand