I recently got a SW Ep1 kit and when I try to use the connection software it keeps telling me that I cannot connect. I tried using com1 and also changed to com 2 on my computer. I made sure all the cables are connected on the pin2k including the mother board and the serial cable is connected properly. I have tried to update on 2 different computers one running XP and one running Win7 and it still gives me the same error.
Does anyone have any suggestions on how to get this to work. Is there any special setting I need to set up on my computer?
I almost have my wife talked into letting me ordering nucore but I cant order it at the moment since pinball life is down at the moment.
I cannot connect to my Pin2k to update code or change game
Re: I cannot connect to my Pin2k to update code or change game
There are lots of things that could be wrong. Read Clay's guide: http://www.pinrepair.com/pin2000/index.htm#update
Not having to update is one of the best features of Nucore![Wink ;-)](./images/smilies/icon_wink.gif)
Not having to update is one of the best features of Nucore
![Wink ;-)](./images/smilies/icon_wink.gif)
Re: I cannot connect to my Pin2k to update code or change game
I have gone over that page like 10 times and it still wont connect. I have finally talked my wife into letting me order Nucore.
I have a question about the full package. Is it trully drop in and play? If I add the arcade vga and audio will I have to install driver for the acade vga or will it be install also?
Thanks
I have a question about the full package. Is it trully drop in and play? If I add the arcade vga and audio will I have to install driver for the acade vga or will it be install also?
Thanks
Re: I cannot connect to my Pin2k to update code or change game
If you buy the arcade vga it comes installed with the driver. Some people have had to adjust their original pin2k monitor for good alignment. There are instructions here that tell you how.ace3093 wrote:I have gone over that page like 10 times and it still wont connect. I have finally talked my wife into letting me order Nucore.
I have a question about the full package. Is it trully drop in and play? If I add the arcade vga and audio will I have to install driver for the acade vga or will it be install also?
Thanks