Hi to this great Forum.
I bought the RFM 2 month ago and it works great with the nurcore system.
But today I startet it and it was hanging here:
I did'nt install the nucore and have no expierience with it.
I hope you have hints for me, I am good in computer work and please help me out of this desaster...
I ran into the same issue. I picked up an RFM recently which had a Nucore system already installed. The machine was running fine for a week, but last night, the system failed to boot up and stopped at the same point as in the OP screenshot. Based on the threads, I focused on the USB -> board coonector. After unplugging/plugging both ends several times, no change. I then swapped to a different USB port on the back of the machine and bingo! Back in business. 5 for 5 reboots so far
My only advice as previously suggested, if there's a way to fix the typo in the subject it would have been a tad easier to find on the forums.