I just bought a new coin door for my RFM but it did not included the coin mechs.

How do I remove the coin Mechs from the old door?

It appears that there are metal pins on the tops of them that are holding them into their holders and once the pins are removed the mechs will drop down and out to the right.

Is this how its done and if so what is used to remove the pins? Thx

Followup for those that may need to remove there coin mechs from the Coin door.

There are NO pins that need to be removed.

Directly facing the coin mech in the door. There is a plastic latch that looks like an inverted T

Carefully pull back the latch by the Horizontal ends of the T it may take a bit of force if the mechs have never been removed before.

It should then just flip up.

Simply remove the coin mech by sliding it down a little and out to the right side.

Reverse these steps to install, making sure that the T snaps back into place.